If it is at 19200, change it to 9600 with the + button.

Make sure the baud rate is set to 9600 and not 19200. Next, press the mode button until you get to the baud rate.

Step 2 – Take your cutter offline by pressing the Online button. Next, press the 2 red carriage limit switch buttons on the inside walls simultaneously 3 times. To reset the cutter, disconnect it from the computer, plug it in and turn it on. Step 1 – It is always a good idea to start by resetting the cutter. These 3 places are the cutter itself, the device manager and in the cutting program. There are 3 places where we need to verify setting so that your cutter communicates properly. Aside from the difference in length, the CR1200 also has an extra stepper motor to drive the sand roller and it has some additional pinch rollers.

The CR630 is a 24″ cutter while the CR1200 is a 48″ cutter. The Creation CR630 and CR1200 vinyl cutters are very similar. Creation PCUT Series cutting Plotter User's manual. We have 1 Creation CT1200 manual available for free PDF download.

Creation pcut ct 1200 driver download